Here is a succession of steps to achieve methodically:
Check well for standards related to the installation of a rain gutter.
Achieve the route of the gutter,
Proceed with the installation of the horizontal gutter.
Gutter installation: perform measurements
This exercise allows to determine precisely:
the exact location of the gutter to retrieve all of stormwater,
the film by the necessary gutter profile,
the characteristics, numbers and types of other elements that make up:
the horizontal gutter (elbow, coupling, birth, angle…),
the descent (downpipe, sleeve, collar),
the system, for an evacuation or water recovery.
Another function of the plot: adapted to the type of fittings and joints in the gutter to allow parts to expand and retract the seasons without weakening or damaging the gutter line.
Gutter installation: how to perform the trace of the gutter?
The horizontal line trace:
for a pending gutter: on the front of chevrons, the top of the gutter should remain approx 2 cm below the roof,
for a creeping gutter: on the strip of double or in the upper part of the rafters.
nail a point at the two extreme points A (side down) and B (opposite side) on a same level line,
calculate the slope, thus identifying low point C of the descent (thus 5 mm below A for 10 meters long),
stretch a string between B and C,
Note the location of a hook every 50 cm,
also locate the square from every angle.
Attention: to strengthen the structure, a hook must be placed at 5 cm from any angle, connection or birth of gutter.
Good to know: some hooks are sold in batches, they are then numbered and present each time a small shift in height compared to the previous, the figure the lowest representative the highest point. These hooks you avoid integrating the slope in the plotting of gutter.
Installing gutter: different types of implementation
Gutter installation can have several types of configuration.
Here are a few possible figures:
a straight gutter without return with:
on one side: a birth of gutter,
the other side: one end because the gutter does not beyond, extends the following facade is not overlooked by a slope of the roof,
a closed gutter on both sides (between two walls for example): an expansion joint must exist at a point at least of this line, at the level of the birth or a junction,
a roof with four slopes:
the gutter surrounds the entire perimeter of the roof,
several expansions shall be provided, at least one per line.
Install a gutter: Assembly or soil and cutting
Before the final installation of your horizontal gutter, it is advisable to assemble on the ground all the gutter (profiles, fittings, births, elbows) elements:
In the case of parts to clip, allows you to train and repeat before climbing on the scale.
In this way, you check that you have all of the components for a continuity of your lines:
number of points of the expansion,
number of hooks to meet.
You can then cut the profiles to the correct length.
This cut must be:
made to the hacksaw,
may be filed in the case of PVC gutters.
Don’t want to deal with your own roof maintenance? To find more about guttering services in Bunbury area in Western Australia, please visit Yellow pages